![]() Garmin does not warrant the performance of the software or that the software will meet your requirements or operate error free. The software is provided on an "as is" basis without warranty of any kind - either expressed or implied - including, without limitation, any implied warranties of merchantability or fitness for a particular purpose. You agree that this license agreement does not need to be signed for it to take effect. This license is personal to you and you may make copies of the software only for your personal use. Title, ownership rights, and intellectual property rights in and to the Software remain in Garmin. ![]() Garmin Corporation ("Garmin") grants you a limited, non-exclusive license to use the upgrade software ("Software") in binary executable form in the normal operation of the applicable Garmin products. Software License Agreementīy downloading, installing, or using this software, you agree to be bound by the terms and conditions of the following license agreement. If the software upload fails, and subsequent upload attempts prove unsuccessful, the unit may need to be returned to Garmin for service. If this software is uploaded to a GPS unit other than the product it is designed for, it will render the unit inoperative. This software should only be uploaded to the unit for which it is intended. These upgrades are specific to the specific GPS units and software versions listed. When I attach the same device to Basecamp, Basecamp tells me I have EU and EU 3D installed, no mention of NA at all, please see second attachment.This download area offers free firmware upgrades for select Garmin® units. There's nothing there to indicate what's already on the device. I have the Zumo connected to MapInstall and it only appears to show me the map from the PC I select, please see the attached image. I don't think I'm following that as I just tried it and I can't see what you are referring to. It's not as helpful if you have several devices that you want the same selection for. So you could install one set of tiles, then reconnect the device and add or subtract some easily. MapInstall does read which maps you have installed on the device and draws them on the map. There's no 3D component for either and I'm not sure all of NA is on there. Western Alaska, Eastern Alaska, Honolulu, Hawaii, If, for example I wanted to install all of NA plus the 3D map on my Zumo how would I do that? I'm asking because I just tried to install those maps using MapInstall by selecting all of NA when I had that map selected and I'm not sure that's what it's done. If something is wrong with a map on a device (mainly with routing) and you created the image with MapSource, I'd try again with MapInstall to at least eliminate one possible point of failure. So the official recommendation is to use MapInstall, not MapSource. ![]() MapInstall supports nMaps (more than one supplemental map), without having to manually rename gmapsupp.img. MapInstall should also be faster in image creation and transfer (depending on the type of map and device) because of performance improvements we made. However, if you launch MapInstall from BaseCamp with data on the device, we will auto-select the tiles that you need to cover the data on the device (the data is also shown in MapInstall). The ability to save map sets is an interesting feature, but is not currently supported by MapInstall. They have been dozens of fixes since MapSource 6.16.3 was released. It might or might not work properly on the device. I want to point out that the image creation code in MapSource is very dated. It's fine to use MapSource if you want, but do so at your own risk.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |